• + (91) 90499 88059


  • You Are Here :
  • Home
  • >> Installation

End preparation for jointing:

Always use KiTEC pipe cutter to ensure burr free cutting. It is necessary that the cut is always at the right angle. Hold the pipe as shown in the figure to ensure right angle cut.
Installation2 Installation3
Push the pipe over the rounding tool, as shown. Rounding of the pipe end is essential. By using rounding tool, the end of the pipe is Properly rounded. The dimensions of the end are properly formed so that perfect sealing takes place in case of external as well as internal sealing fittings.
It is always essential to chamfer the end of the pipe when pipe is used with brass as well as composite internal sealing fittings. The chamfering of the pipe protects the 'O' rings against any damage while pushing the pipe over the fitting.
Installation4 Installation5